Table of Contents
Advertisement
AXIS Q60-S Series
The Axis product can be installed with the cables routed through or along the wall or roof.
Read all the instructions before installing the product. Some installation steps would benefit from
being completed together because they require removal of the dome cover.
A hardware installation can include the following:
•
The product is supplied with a clear dome cover (premounted). A smoked dome cover is
available as an accessory. To replace the dome cover, see page 19.
•
A standard or high capacity SD card (not included) can be used to store recordings locally
in the product. To install an SD card, see page 19.
•
To install the product using a T91C61 Wall Mount (sold separately), see page 27.
Attach the Sunshield
Attaching the sunshield is optional. The sunshield helps keep the temperature inside the camera
down.
1. Remove the screw plugs from the camera unit.
2. Place the sunshield on the camera unit.
3. Secure the sunshield using the supplied screws.
Replace the Dome Cover
Replacing the dome cover is only necessary if you want to use a smoked dome cover or if the
dome cover is scratched or damaged. Smoked dome covers and spare clear dome covers can be
purchased from your Axis reseller.
1. Loosen the dome ring screws and remove the dome cover.
2. Remove the dome bracket screws and remove the dome bracket and the dome cover
from the dome ring.
3. Make sure the rubber gasket is fitted correctly on the dome cover.
4. Attach the dome bracket and the dome cover to the dome ring and tighten the screws
(torque 3.2 Nm).
5. To install an SD card (not included), see Install an SD Card, on page 19.
6. Attach the dome cover to the top cover and tighten the screws (torque 3.2 Nm).
Install an SD Card
It is optional to install an SD card (not included), which can be used for local recording with
removable storage.
1. Loosen the dome ring screws and remove the dome cover.
2. Insert an SD card (not included) into the SD card slot.
19
Advertisement
Table of Contents
