Install The Hardware - Axis Q6042-S PTZ Installation Manual

I/O terminal connector (external)
6-pin terminal blocks for:
• Digital Input/Output
• Power (DC output)
• Ground (GND)
Function
GND
DC output
Configurable
I/O 1 (Input or Output)
Configurable
I/O 2 (Input or Output)
I/O terminal connector (internal)
2-pin terminal block.

Install the Hardware

NOTICE NOTICE NOTICE
• The product shall be connected using a shielded network cable (STP) or an optical fiber
cable. All cables connecting the product to the network shall be intended for their
specific use. Make sure that the network devices are installed in accordance with
the manufacturer's instructions. For information about regulatory requirements, see
Regulatory Information, on page 2 .
• Mount the product with the dome cover facing downward.
• Be careful not to scratch, damage or leave fingerprints on the dome cover because this
could decrease image quality. If possible, keep the protective plastic on the dome cover
until the installation is complete.
Pin Notes
1, 4, 6
Ground
2
Power out
3
Digital input
Digital output (transistor –
open collector)
5
Digital input
Digital output (transistor –
open collector)
18
AXIS Q60-S Series
Specifications
12 V DC, 50 mA
0 to +30 V DC
Max load = 100 mA
Max voltage =
+30 V DC
0 to +30 V DC
Max load = 100 mA
Max voltage =
+30 V DC