Advertisement
ILLUSTRATION
A
F
G
E
B
C
D
A. Grill Hub
B. Screw
C. Washer
D. Grill Ring
E. Front Grill
F. Blade Nut
G. Blade
H. Rear Grill Mounting-Nut
I. Metal Plate
J. Rear Grill
K. Motor Shaft
L. Motor Housing Prong
M. Handle
N. Oscillation Knob
OPERATING INSTRUCTIONS
Step 1: Set the fan base on a dry, level surface.
Step 2: Please make sure the On/Speed lever is in the "Off"
position. Plug the cord into any standard 120-volt A/C
outlet.
Step 3: The SPEED is adjusted by moving the lever up or down to
the desired setting.
Step 4: The OSCILLATION control knob is located on the top of
the fan motor housing. To start oscillation, push control
knob down. To stop oscillation, pull control knob up.
ADJUSTMENT INSTRUCTIONS
Tilt Adjustment
To change the tilting angle of the fan head, move the fan head
to the desired angle.
K L
P
H
I
Q
J
R
S
O. Motor Housing
P. Pole
Q. Speed Control Lever
R. Base
S. Base Nut
CLEANING/MAINTENANCE
Follow these instructions to correctly and safely care for your
M
Holmes table fan. Please remember:
N
• Always unplug the fan before cleaning or disassembling.
O
• Do not allow water to drip on or into the fan motor housing.
• Do not use any of the following as a cleaner: gasoline, thinner,
benzine
(See instructions for fan head assembly)
Step 1: To access the fan blade, remove the front grill and the
fan blade nut.
Step 2: Clean the fan blade, both front and rear grills with a soft
cloth moistened with a mild soap solution.
Step 3: Replace blade, tighten the fan blade nut, and securely
fasten the front grill.
Fan Head and Base Cleaning
Using a soft, moist cloth, with or without a mild soap solution,
carefully clean the fan base and head. Please use caution
around the motor housing area. Do not allow the motor or
other electrical components to be exposed to water.
FAN STORAGE
Your fan can be stored in the off-season either partially disas-
sembled or assembled. It is important to keep it in a safe, dry
location.
• If stored disassembled, we recommend using the original (or
appropriately sized) box.
• If stored assembled or partially assembled, remember to
protect the fan head from dust.
Advertisement
