Holmes Blizzard HAOF951T - Oscillating Power Fan Manual

Also See for Blizzard HAOF951T:

Owner's manual (2 pages)

Table of Contents

Contents

1 ASSEMBLY INSTRUCTIONS
2 OPERATING INSTRUCTIONS
3 CLEANING/MAINTENANCE INSTRUCTIONS
4 FAN STORAGE
5 Documents / Resources
- 5.1 Download manual

Holmes Blizzard HAOF951T - Oscillating Power Fan Manual

ASSEMBLY INSTRUCTIONS

Your Table Fan comes completely assembled and is ready for immediate use. Carefully unpack your fan, read the instructions completely, plug it in and enjoy.

ASSEMBLY INSTRUCTIONS
Fig.1

OPERATING INSTRUCTIONS

Your fan is equipped with the technologically advanced 1Touch^® Thermostat. You can set the fan to run continuously on a manual mode or set the 1Touch^® Thermostat to your desired temperature setting. The 1Touch^® Thermostat will automatically turn your fan ON or OFF according to changes in the room's temperature based on your preset temperature setting. The comfort level ranges between 60 degrees and 80 degrees Fahrenheit. Example: If you set your fan to 75 degrees and the temperature in the room is 78 degrees then the fan will turn off when your set temperature is reached. The fan will then turn on again when the temperature rises above your desired temperature setting.

Set fan on a dry, level surface.
Plug cord into any standard 120 volt AC outlet.
The speed/mode is adjustable by pushing the Mode/OFF ( ) button located on the front of the control housing. Each push of the button will cycle though Manual High, Manual Low, Auto High 60, 65, 70, 75, 80 degrees F, Auto Low 60, 65, 70, 75, 80 degrees F and then to OFF.

warning Note: that if you hold the mode/off button down for 2 seconds, the fan will turn off while remembering its last setting. The last fan setting will return when turned on again.

Oscillation

The Oscillation Switch ( ) is located at the back of the fan motor housing. Pull the switch up for oscillation.
Press the switch down to stop the motion.

Adjustable-Tilt Head

Pull up the Tilt-Adjustment Lever to release the fan head locking mechanism. The fan head will have the capability to rotate in a vertical direction forward as well as back to a 90 degree position with the lever depressed. Release lever to lock into place.

Wall-Mount Position

After selecting a suitable location on the wall, use themounting location guide below to ensure proper placement.
Use the holes as a guide and mark the correct place where the screws will be inserted. Consult with a Hardware or Home Center representative for best screws for your wall type.
Secure the screws into the wall leaving enough roomto slide the holes located underneath the base over the screw heads.

CLEANING/MAINTENANCE INSTRUCTIONS

Follow these instructions to correctly and safely care for your fan. Please remember:

Always unplug the fan before cleaning or disassembling.
Do not allow water to drip on or enter into fan housing.
Be sure to use a soft cloth moistened with a mild soap solution.
Do not use any of the following as a cleaner: gasoline, thinner, or benzene.

Fan Cleaning
Clean the fan blade, grill, housing and base with a soft, damp cloth. Please use caution around the motor housing area. Do not allow the motor or other electrical components to be exposed to water.

FAN STORAGE

When storing your fan in the off season, it is important to keep it in a safe dry location. It is important to protect the fan head from dust. We strongly recommend using the original box from purchase.

If you have any questions regarding your product or would like to learn more about other Holmes^® products, please contact our Consumer Service Department at 1-800-546-5637 or visit our website at www.holmesproducts.com