Table of Contents
Advertisement
12. Connector Pinouts
TRS jacks of analog input / output
The stereo ¼ " TRS jacks of the analog inputs and outputs are wired according to international
standards:
Tip = + (hot)
Ring = – (cold)
Sleeve = GND
The servo balanced input and output circuitry allows to use monaural TS jacks (unbalanced)
with no loss in level. This is the same as when using a TRS-jack with ring connected to ground.
XLR jacks of analog input / output
The XLR connectors are wired according to international standards:
1 = GND (shield)
2 = + (hot)
3 = - (cold)
TRS Phones jack
The analog monitor output on the front
is accessible through a stereo ¼ " TRS
jack. This allows a direct connection of
headphones. In case the output should
operate as Line output, an adapter
TRS plug to RCA phono plugs, or TRS
plug to TS plugs is required.
The pin assignment follows interna-
tional standards. The left channel is
connected to the tip, the right channel
to the ring of the TRS jack/plug.
User's Guide ADI-2 © RME
14
Advertisement
Table of Contents
