Table of Contents
Advertisement
21
• Fit the saddlebag over a rear wheel.
• Insert four screws through the saddlebag and into
the vehicle.
• Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
• Repeat this procedure to assemble the other saddlebag
to the rear end of the vehicle.
22
Battery
Compartment
Sound Box
SHOWN ACTUAL SIZE
• Loosen the screw in the sound box battery compartment
door using a Phillips screwdriver and open the battery
compartment door.
• Insert three "AA" (LR6) alkaline batteries in the sound
box as indicated in the battery compartment.
• Close the battery compartment door and tighten the
screw using a Phillips screwdriver. Do not over-tighten.
Hint: For longest battery life, use only alkaline batteries.
Rear Wheel
Saddlebag
Battery
Compartment
Door
1.5V x 3
"AA" (LR6)
Assembly
Battery Tips
• Do not mix old and new batteries.
• Do not mix different types of batteries: alkaline, standard
(carbon-zinc) or rechargeable (nickel-cadmium).
• Remove the batteries during long periods of non-use.
Always remove exhausted batteries from the sound box.
Battery leakage and corrosion can damage the vehicle.
Dispose of batteries safely.
• Do not dispose of batteries in a fire. The batteries may
explode or leak.
• Never short circuit the battery terminals.
• Non-rechargeable batteries are not to be recharged.
• Only batteries of the same or equivalent type as recom-
mended in these instructions are to be used.
• If removable rechargeable batteries are used, they are
only to be charged under adult supervision.
• Rechargeable batteries are to be removed from the
sound box before they are charged.
• If you use a battery charger, it should be examined regu-
larly for damage to the cord, plug, enclosure and other
parts. Do not use a damaged battery charger until it has
been properly repaired.
• When sound from the vehicle becomes faint or stops, it's
time for an adult to replace the batteries!
23
• Balance the sound box on the vehicle. (The speaker
should face down.)
• Fit the gas tank to the vehicle, as shown.
• Insert two screws through the gas tank and into the
vehicle. Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
14
Gas Tank
Sound
Box
Advertisement
Table of Contents
