Peel-Off (Self-Strip) - Intermec EasyCoder PM4i User Manual

Chapter 4—Media Load
Peel-Off (Self-strip)
The EasyCoder PM4i can print on labels, tickets, tags, and continuous
stock in various forms. This section describes the case when self-adhesive
labels are separated from the liner immediately after printing, which
requires optional integral self-strip unit with liner takeup. This is also
known as "Self-strip" operation.
Peel-off operation cannot be performed when an optional fan-fold guide
fi tted.
Peel-off can only be used for:
• Self-adhesive labels with liner
An optional label-taken sensor can hold the printing of the next label
in a batch until the present label has been removed, see Chapter 8,
"Options."
Note: Save the label indicating the sensitivity number attached
to the media roll. You will need this number to set the media
sensitivity, see Appendix E.
Note: Peel-off operation sets high demands on the media in
regard of label stiffness, release characteristics of the adhesive
and liner, resistance against electrostatic charging etc., so the
labels will be dispensed properly. Consult your media supplier
or test the media to ascertain that it is suitable for your
application.
22 Intermec EasyCoder PM4i—User's Guide (IPL version)