Test Menu - Epson Stylus Pro 9500 Service Manual

EPSON Stylus Pro 9500

5.2.5 Test Menu

The Test menu tests or checks the operation of the control circuit board.
This menu is also to used for operation checks of
each of the sensors, etc. in Chapter 3,
"Troubleshooting."
Table 5-10. Test Menu Items
Test Item
o
Program
Version
o
Backup parameters
o
DIP-SW
o
Board Rev.
o
Panel buttons
Control Panel
o
LCD panel display
o
LED indicators
Sensors HP, Cover Open, Release Lever, P_FRONT, P_Rear,
Paper Thickness, PG, Thermistor, I/C Holder Levers,
Ink ID, I/C, and Ink Low
Encoder CR Motor, PF Motor
Fan On/Off confirmation
o
Maintenance Record
Elec.
o
Fatal Error Record
D/A Revision Factory use for Head voltage correction - do not attempt
Head Signal Factory use for Head pulse check - do not attempt
NOTE: The D/A correction in the above table should not be
implemented.
Adjustment
Description
Adjustment Steps
The menu items and their order in the menu are shown below.
[Pause] returns you
to previous menu
[SelecType]
Test: Version
Test: Panel
Test: Sensor
Test: Encoder
Test: Fan
Test: Elec.
Test: D/A Revision
Test: Head Signal
[Item]
Revision A
[Enter]
Other
menus
[Pause]
189