Connecting Video Source Devices - BenQ Joybee GP3 User Manual

To disconnect the projector from a computer:
i. Click
ii. Click the pop-up message.
iii. Disconnect the USB cable only when the message says that it is safe to remove
the hardware.
• Do not disconnect the USB cable while the files are being copied, as this could result in loss
of data or damage to the projector.
• The connection will not end if you have projector files open on the computer. Close all
projector files and try again.
• Other versions of Windows operate similarly. Follow the correct procedure for removing a
USB device from your computer safely for your version of Windows.

Connecting Video source devices

You need only connect the projector to a Video source device using just one of the above
connecting methods, however each provides a different level of video quality. The method
you choose will most likely depend upon the availability of matching terminals on both the
projector and the Video source device as described below:
Terminal name
Mini HDMI
Component Video
Video
If the selected video image is not displayed after the projector is turned on and the correct video
source has been selected, check that the Video source device is turned on and operating
correctly. Also check that the signal cables have been connected correctly.
on the Windows Taskbar.
Terminal appearance
Mini HDMI
VGA
Video
Picture quality
Best
Better
Good
Connection
27