ActionTec V1000H User Manual page 9

VDSL2/GigE Wireless 11n Gateway
LAN Ethernet Ports (4)
The LAN Ethernet ports are used to connect computers to the Gateway via
Ethernet cable. The Ethernet ports are 10/100/1000 Mbps auto-sensing ports,
and either a straight-through or crossover Ethernet cable can be used when con-
necting to the ports.
WAN Ethernet Port
The WAN Ethernet port is used to connect the Gateway to a WAN via an
Ethernet cable.
USB Port
Reset Switch
Depressing the Reset switch for one second will restore the Gateway's factory
default settings. To reset the Gateway, depress and hold the Reset switch for
ten seconds. The reset process will start after releasing the switch.
Power Port
The Power port is used to connect the Power cord to the Gateway.
WARNING! Do not unplug the Power cord from the Gateway dur-
ing the reset process. Doing so may result in permanent damage to the
Gateway.
6