Table of Contents
Advertisement
91-000197-020-000_E5925B_R0.qxd
Appendix
In case of difficulty
Incomplete
messages
Difficulty hear-
ing messages
System does
not answer
after correct
number of rings
"CL" flashes in
message window
System does
not respond
to remote
commands
Announcement
message is not
clear
2/13/1950
• If a caller leaves a very long message, part of it may be lost when the
system disconnects the call after 4 minutes.
• If the caller pauses for more than 7 seconds, the system stops
recording and disconnects the call.
• If the system's memory becomes full during a message, the system
stops recording and disconnects the call.
^
• Press
on the base to increase speaker volume.
• Make sure that the answering system is on.
• If Toll Saver is activated, the number of rings changes to 2 when you
have new messages waiting (see page 26).
• In some cases, the system may be affected by the ringing system
used by the local telephone company.
• If the memory is full or the system is off, the system will answer after
10 rings.
• You need to reset the answering system clock (see page 23).
• Make sure to enter your remote access code correctly (see page 30).
• Make sure you are calling from a touch-tone phone. When you dial a
number, you should hear tones. If you hear clicks, the phone is not a
touch-tone telephone and cannot activate the answering system.
• The answering system may not detect the remote access code while
your announcement is playing. Try waiting until the announcement is
over before entering the code.
• There may be noise or interference on the phone line you are using.
Press dial-pad buttons firmly.
• When you record your announcement, make sure you speak in a
normal tone of voice, about nine inches from the base.
• Make sure there is no background noise (TV, music, etc.) while you
are recording.
33
7:21 PM
Page 33
Advertisement
Table of Contents
