Char-Broil 463270913 Product Manual page 20

13 Inside of cart, insert rear shield tab into left slot on upper of lower back panel.
into slots beneath grease tray opening in upper back panel, shown A. Attach front shield tabs under front brace
and attach right and left rails under front brace with three #8x3/8" self-tapping screws, shown B.
Tank heat shield
Tank heat shield
14
Release the cap and nut from electronic ignition module. Attach electronic ignition module to cart right side panel
with the nut and cap, shown A.
Connect each of the wires from main burner electrodes and sideburner electrode into the back of Electronic
Ignition Module. Total (4) connections. Connect the two wires{(a) and (b)} from switch wiring harness into the
back of Electronic Ignition Module. Total (2) connections.
NOTE: Switch terminals are larger than electrode terminals and should only be installed in location shown
as (a),(b).
Electronic ignition
module
20
*This side UP
Note: some parts omitted
for clarity of illustration
Lower back panel
Left rail
Right rail
Nut
Tank heat shield
A
#8x3/8" self-tapping
A
Cap
Insert left and right grease tray rails
Front Brace
Left rail
screw
Grease tray opening
1
2
(a)
3
4
(b)
Wire
B
Right rail
B