Char-Broil 463270913 Product Manual page 18

First, remove the two screws and washers factory attached to the sideburner valve bracket. Position sideburner
9
valve bracket beneath sideburner shelf fascia so that valve stem comes through larger center hole in fascia. Align
the holes on valve bracket with left and right holes on fascia. Secure using screws and washers that were
removed from bracket.
Next, place sideburner bezel over valve stem on front side of fascia. Align small holes on bezel with upper and
lower holes on fascia. Attach bezel to fascia using two #8-32x3/8" screws. Press sideburner control knob onto
valve stem.
Screws and Washers
removed from valve bracket
Sideburner
fascia
Valve stem
10
Insert sideburner burner into left shelf,
pan, shown A.
sideburner valve, shown C.
B
Wing nut
C
18
Note: Use left and right
holes on fascia to attach
valve bracket
Sideburner
valve bracket
The stud on bottom of burner fits into rear small hole in sideburner drip
Secure burner to sideburner drip pan with one Wing nut, shown . Make sure burner tube engages
Sideburner drip pan
Control knob bezel
Install bezel with OFF at top
Sideburner drip pan
#8-32x3/8" screw
Sideburner bezel
Note: Use upper and lower holes
on fascia to attach bezel
B
Sideburner burner
Valve stem
A