Husqvarna 42 Workshop Manual page 55

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
Always use new crankshaft seals. Begin with
the ignition side. Apply grease to the crankshaft
seal lip and carefully slide the seal over the end
of the crankshaft. The open side of the seal
must face inward. Drive the seal into the
crankcase using tool P/N 5025082-01 until
the seal is flush with the crankcase. Install the
drive side crankshaft seal in the same manner.
The remainder of reassembly of the unit is the
reverse of disassembly. Refer to the appropri-
ate sections for reassembly instructions.
Crankcase and Crankshaft
www.mymowerparts.com
12
53