Table of Contents
Advertisement
symptoms. However, this is not to state that this projector can operate under any and all
harsh or extreme conditions.
Adjusting the sound
The sound adjustments made as below will have an effect on the projector speaker(s). Be
sure you have made a correct connection to the projector audio input. See
on page 16
for how the audio input is connected.
Muting the sound
To temporarily turn off the sound:
1.
Press MENU/EXIT and then press
menu is highlighted.
2.
Press
Settings page appears.
3.
Highlight Mute and press
If available, you can also press Mute on the remote control to toggle projector audio between on and off.
Adjusting the sound level
To adjust the sound level, press Volume +/- or
1.
Repeat steps 1-2 above.
2.
Press
Turning off the Power On/Off Ring Tone
To turn off the ring tone:
1.
Repeat steps 1-2 above.
2.
Press
The only way to change Power On/Off Ring Tone is setting On or Off here. Setting the sound mute or
changing the sound level will not affect the Power On/Off Ring Tone.
Using the test pattern
The projector is able to display the grid test
pattern. It helps you adjust the image size and
focus and check that the projected image is free
from distortion.
To display the test pattern, open the OSD menu
and go to the SYSTEM SETUP: Advanced >
Test Pattern and press
to highlight Audio Settings and press MODE/ENTER. The Audio
/
to highlight Volume and press
to highlight Power On/Off Ring Tone and press
/
to select On.
/
until the SYSTEM SETUP: Advanced
to select On.
/
, or:
/
to select a desired sound level.
"Connection"
/
to select Off.
Operation
33
Hide quick links:
Advertisement
Table of Contents
