Table of Contents
Advertisement
Step 7. Hang the loosely tightened bolts on the wall
bracket.
Step 8. Install bolts in left- and right-side mounting
holes located in the upper part of the
speaker bracket.
Step 9. Securely tighten all bolts.
Step 10. Remove the hoisting bracket, then replace
the 8 screws removed in Step 4.
Tip
The
performance
maintained even if the bracket is mounted
as it is.
Note
Left and right angles can be adjusted within a range
of 0° – 90°.
If no angle adjustments are required, this completes
the installation. When performing angle adjustments,
please refer to "Angle Adjustment" on p. 31.
[completed Mounting (2-Unit configuration)]
of
the
speaker
is
Note: For Completed Mountings and Completed Mounting Dimensional
Diagrams in 3-unit and 4-unit configurations, see p. 30.
[Enlarged figure of previous page Part A]
7
Hang on wall bracket.
Speaker bracket
of the SR-D8WB
Supplied with
*
3
the SR-D8WB
[completed Dimensional Diagram (2-Unit
configuration) with Hoisting bracket Mounted]
373 (14.69)
118 (4.65)
*
These dimensions are the same as
4
those in 3-unit and 4-unit configurations.
Wall bracket of
the SR-D8WB
Hex bolt M10×30
(with spring and
plain washers)*
3
8
7
Unit: mm (in)
29
Advertisement
Table of Contents
