Ryobi AIRGRIP EZ REACH ELB001 Operator's Manual page 9

ATTACHING ADJUSTABLE EXTENSION POLE
TO STICK DRIVER
See Figure 2.
 Twist threaded end of extension pole counterclockwise
into threaded receptacle of stick driver.
 Turn locking screw on stick driver to secure.
 Turn bottom portion of pole clockwise to extend or retract
top portion of pole to desired length.
 Turn bottom portion of pole counterclockwise to lock
pole into position.
NOTE: Any standard extension pole can be used with the
EZ Reach system. When fully extended, length of the pole
and assembled EZ Reach system should not exceed 12 ft.
ADJUSTING STICK DRIVER
See Figure 3.
 Turn stick driver pivot knob counterclockwise.
 Pivot stick driver head to desired angle.
 Turn pivot knob clockwise to lock into position.
ATTACHING AIRGRIP™ SYSTEM
See Figure 4.
 Align groove in AIRgrip system with groove in stick
driver.
 Slide AIRgrip into place.
NOTE: Ensure AIRgrip is locked into place before using.
To remove:
 Push down on release button on stick driver.
 Slide AIRgrip off of stick driver.
ASSEMBLY
EXTENSION POLE
PIVOT KNOB
AIRGRIP™ SYSTEM
RELEASE BUTTON
STICK DRIVER
9
STICK DRIVER
LOCKING SCREW
Fig. 2
Fig. 3
Fig. 4