Ryobi AIRGRIP EZ REACH ELB001 Operator's Manual page 12

Before using the EZ Reach system, push each remote control
button to ensure the stick driver and AIRgrip system are
working correctly.
CAUTION:
If more than one unit is being used in the same location,
keep a minimum distance of 20 ft. between the units to
prevent interference of wireless remote connections of
one or both units.
To remove light bulb:
NOTE: Allow light bulb to cool before placing suction head
over bulb.
 Place suction head over center of light bulb while keeping
AIRgrip body in line with socket.
 Press grip/release button on remote control to activate
suction. You will hear a low-pitched buzzing sound.
 Gently push the AIRgrip system against the light bulb until
you hear a high-pitched buzzing sound. This means the
AIRgrip has successfully attached onto the light bulb.
NOTE: Make sure suction head is completely attached to
light bulb by gently pulling EZ Reach system away from
bulb. If suction head moves, the AIRgrip has not attached
onto the light bulb.
 Press and hold the OUT button on remote control. The
stick driver will begin to unscrew the light bulb.
 Release remote control button once light bulb is
completely unscrewed from socket.
 Remove bulb from socket and lower pole.
 Grasp light bulb with your hand.
 Press and hold grip/release button on AIRgrip with
opposite hand for approximately three seconds until
suction is deactivated. Bulb will be released from the
AIRgrip system.
To install light bulb:
 Press grip/release button on AIRgrip to active suction.
You will hear a low-pitched buzzing sound.
 Gently push the light bulb head against the AIRgrip
suction head until you hear a high-pitched buzzing sound.
This means the AIRgrip has successfully attached onto
the light bulb.
NOTE: Make sure suction head is completely attached
to light bulb by gently pulling bulb away from EZ Reach
system. If suction head moves, the AIRgrip has not
attached onto the light bulb.
OPERATION
GRIP/RELEASE BUTTON
OUT (REMOVE)
 Raise light bulb to light socket.
 Press and hold the IN button on remote control. The
stick driver will begin to screw the light bulb into the light
socket.
 Release remote control button once light bulb is
completely screwed into socket.
 Press grip/release button on remote control for
approximately three seconds until suction is deactivated.
The AIRgrip system will release the bulb.
NOTE: Make sure light bulb is completely screwed into
light socket and secured before pressing remote control
grip/release button.
 Slide the ON/OFF switch on the AIRgrip system to the
OFF ( O ) position and push power button on stick driver
to turn off until next use.
12
IN (INSTALL)
Fig. 11