Table of Contents
Advertisement
Do not use EZ Reach on a hot bulb. Turn off light switch
and allow previously lit light bulb to cool.
Do not use EZ Reach on free hanging light fixtures.
Only use on light sockets and fixtures that are fixed in
place.
Remove all batteries from the power tool if you will
not be using the power tool for an extended time.
Know your power tool. Read operator's manual care-
fully. Learn its applications and limitations, as well as
the specific potential hazards related to this power
tool. Following this rule will reduce the risk of electric
shock, fire, or serious injury.
Battery tools do not have to be plugged into an elec-
trical outlet; therefore, they are always in operating
condition. Be aware of possible hazards when not
using your battery tool or when changing accessories.
Following this rule will reduce the risk of electric shock,
fire, or serious personal injury.
Do not place battery tools or their batteries near fire
or heat. This will reduce the risk of explosion and pos-
sibly injury.
Batteries vent hydrogen gas and can explode in the
presence of a source of ignition, such as a pilot light.
To reduce the risk of serious personal injury, never use
any cordless product in the presence of open flame. An
exploded battery can propel debris and chemicals. If
exposed, flush with water immediately.
SPECIFIC SAFETY RULES
Under extreme usage or temperature conditions,
battery leakage may occur. If liquid comes in contact
with your skin, wash immediately with soap and water,
then neutralize with lemon juice or vinegar. If liquid
gets into your eyes, flush them with clean water for
at least 10 minutes, then seek immediate medical at-
tention. Following this rule will reduce the risk of serious
personal injury.
FCC Statement: This equipment generates, uses, and
can radiate radio frequency energy and, if not installed
and used according to the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harm-
ful interference to radio or television reception, which is
found by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
the devices.
Consult a dealer or an experienced radio/television
technician for assistance.
If more than one unit is being used in the same
location, keep a minimum distance of 20 ft. between
the units.
4
Advertisement
Table of Contents
