Connecting The Optical Fiber Cable For Fibre Channel (Saite1300-F Only) - Sony SAITe1300-F Operating Instructions Manual

Connecting the Optical Fiber Cable for Fibre Channel
(SAITe1300-F only)
The SAITe1300-F is equipped with an interface that complies with the Fibre
Channel standards with the following specifications.
• Short-wave laser
• 200 MB/sec
• Duplex LC Fibre Channel connectors
The equipment (HBA, hub, switch, etc.) to be connected to the SAITe1300-F
must be of the same type.
Use an optical fiber cable with the following specifications.
• Duplex LC Fibre Channel connectors
• 50/125 µm multimode optical fiber cable
Caution
• If your interface and optical fiber cable are different types, the unit may not
operate correctly when connected.
• Turn off the unit when connecting or disconnecting a cable to the fibre
channel connector. Failing to do so may result in damage.
• Never touch the fibre channel connector of the unit when the unit is on. Doing
so may result in damage.
FIBRE CHANNEL
Host bus adaptor
(FC HBA)
Host computer
or
HUB, switch, etc.
FIBRE CHANNEL
Optical fiber cable for fibre channel*
* 50/125 µm, MMF, Duplex LC
FIBRE CHANNEL
Optical fiber
cable for fibre
channel*
Chapter 2 Installation
29