Setting The Dip Switches; If Necessary, Change The Settings As Follows - Sony SAITe1300-F Operating Instructions Manual

Setting the DIP Switches

If necessary, change the settings as follows

By setting the DIP switches at the bottom of the S-AIT Tape Drive Unit, you
can:
• Choose whether to compress the data when recording.
• Choose whether the host can control data compression.
The default settings of the DIP switches is as follows.
• DC Control-1: ON
Compression is enabled.
• DC Control-2: OFF
The host can control compression.
Caution
Before removing the access cover to change DIP switch settings of the S-AIT
Tape Drive Unit, turn off the unit and disconnect the power cable.
1
Make sure that the unit is off.
2
Remove the two screws with a screwdriver and remove the access cover
Screw
Access cover
DIP switches
19
Chapter 2 Installation