System Memory; Removing A Memory Module; Replacing A Memory Module - Dell OptiPlex GX400 Service Manual

Back to Contents Page

System Memory

Dell™ OptiPlex™ GX400 Service Manual
Removing a Memory Module
Replacing a Memory Module

Removing a Memory Module

CAUTION: Before you perform this procedure, see
CAUTION: RIMMs can get very hot during system operation. Be sure that the RIMMs have had sufficient time to cool before you touch them.
NOTICE: Before disconnecting a device from the computer or removing a component from the system board, verify that the standby power light on the system
board has turned off. To locate this light, see
1. Turn off the computer and devices, disconnect them from their electrical outlets, wait at least 5 seconds, and then
2. Lay the computer on its right side.
3. Rotate the power supply away from the system board.
4. Remove the memory modules (RIMMs or CRIMMs):
a. Press the securing clips at each end of the socket outward simultaneously until the module pops out slightly from the socket.
b. Lift the module away from the socket.
NOTE: If you remove a module (RIMM or CRIMM), you must install another module in the empty socket before turning on the computer.
Removing a Memory Module

Replacing a Memory Module

1. Install the memory module:
a. Press the securing clips at each end of the socket outward until they snap open.
b. Align the slots on the bottom of the memory module with the two ridges inside the socket.
c. Press the memory module straight down into the socket until the securing clips snap into place at the ends of the module.
Installing a Memory Module
"Precautionary Measures."
"System Board Components."
remove the computer cover.