Back to Contents Page
Expansion-Card Guide
Dell™ OptiPlex™ GX400 Service Manual
Removing the Expansion-Card Guide
Replacing the Expansion-Card Guide
Removing the Expansion-Card Guide
CAUTION:
Before you perform this procedure, see
NOTICE:
Before disconnecting a device from the computer or removing a component from the system board, verify that the standby power light on the system
board has turned off. To locate this light, see
1. Turn off the computer and devices, disconnect them from their electrical outlets, wait at least 5 seconds, and then
2.
Remove the AGP card brace
3.
Remove all expansion
cards.
4.
Rotate the hard-drive bracket
5. Remove the expansion-card guide:
a. From the outside of the chassis, press in the tab.
This will release the card-guide tab from the chassis.
b. Rotate the released side of the card guide away from the front chassis wall.
c. With the released side of the card guide away from the chassis wall, pull the card guide up away from the chassis.
Removing the Expansion-Card Guide
Replacing the Expansion-Card Guide
Insert the two bottom tabs in the slots in the chassis wall. Then, rotate the card guide toward the front chassis wall until the top tab snaps into the slot in the front chassis
wall. See
"Removing the Expansion-Card
"Precautionary
"System Board
Components."
or the
AGP card
clip.
out and remove it from the chassis.
Guide."
Measures."
remove the computer
cover.