Dell OptiPlex GX260 Service Manual page 72
Small form-factor, small desktop, and small mini-tower computers
Hide thumbs
Also See for OptiPlex GX260:
- System user's manual (236 pages) ,
- User manual (31 pages) ,
- Disassembly (27 pages)
Table of Contents
Advertisement
Back to Contents Page
Microprocessor
Dell™ OptiPlex™ GX260 Service Manual
Removing and Installing the Heat-Sink Assembly and Microprocessor
Small Form-Factor and Small Desktop Computers
Small Mini-Tower Computer
Small Form-Factor and Small Desktop Computers
1. Disconnect the cooling fan power cable from the FAN connector on the system board.
2. Disconnect the 12-volt power cable from the 12VPOWER connector on the system board.
3. Remove the heat sink/blower assembly.
a. The heat sink is attached to the blower. Press and lower the green lever on the retention mechanism until it is
parallel to the system board.
b. Gently rock the heat sink, and then slightly twist it as you lift it from the microprocessor.
NOTICE:
Lay the heat sink down with the thermal solution facing upward.
Heat Sink/Blower Assembly Removal
Hide quick links:
Advertisement
Table of Contents
