Removing The Microprocessor Airflow Shroud (Mini Tower Chassis); Replacing The Microprocessor Airflow Shroud (Mini Tower Chassis) - Dell Precision 330 Service Manual

Mini Tower Chassis
Removing the microprocessor airflow shroud
l
Replacing the microprocessor airflow shroud
l

Removing the Microprocessor Airflow Shroud (Mini Tower Chassis)

CAUTION: Before you perform this procedure, see
NOTICE: Before disconnecting a peripheral from the system or removing a component from the system board, verify that the standby power indicator on the
system board has turned off. To locate this indicator, see
1. Turn off the computer and peripherals, disconnect them from their electrical outlets, wait at least 5 seconds, and then
2. Rotate the power supply away from the system board.
3. Remove the airflow shroud by pulling back the release tabs on the top of the shroud and lifting the shroud up until the anchor tabs disengage from the chassis
frame. See "Removing the Airflow Shroud (Mini Tower
Removing the Airflow Shroud (Mini Tower Chassis)

Replacing the Microprocessor Airflow Shroud (Mini Tower Chassis)

To replace the microprocessor airflow shroud, perform the
Back to Contents Page
"Precautionary Measures."
"System Board Components" or
Chassis)." Then lift the airflow shroud out of the chassis.
removal procedure in reverse.
"Interior Service Label."
remove the computer cover.