Turning Off The Power - Hitachi CP-S225 User Manual

TURNING OFF THE POWER

STANDBY/ON
VIDEO RGB SEARCH
ASPECT AUTO BLANK
VOLUME
MAGNIFY
ON
MUTE
OFF
FREEZE KEYSTONE
POSITION MENU
ENTER
ESC RESET
Control panel
STANDBY/ON INPUT KEYSTONE RESET
NOTE
• Except in
emergencies, follow
the above-
mentioned
procedure for
turning power off.
16
Press the STANDBY/ON button (control
1
panel or remote control)
The message "Power off?" will appear on the screen for approximately 5 seconds.
Press the STANDBY/ON button again
2
(control panel or remote control)
Press the STANDBY/ON button again while the "Power off?"
message is visible. The projector lamp goes off and starts cooling
down. The POWER indicator blinks orange while the lamp cools
down. (Pressing the STANDBY/ON button while the POWER
indicator is blinking orange has no effect.)
The system goes into the STANDBY mode after
cooling down and the POWER indicator stops
blinking orange and then lights to solid orange.
Check that the POWER
3
indicator stops
blinking and lights to
LANP
solid orange.
TENP
POWER
Switch the power
switch to [O] (OFF).
Confirm that the POWER indicator has gone
4
off and then close the slide lens door.
When the projector has completed powering down, the
POWER indicator will go off.
STANDBY/ON
power switch
STANDBY/ON
POWER indicator