Table of Contents
Advertisement
Power on/off
Power on/off
Turning on the power
Turn on the projector and the connected devices. Turn on the projector ahead of
other connected devices, unless mentioned in the manuals.
For this projector, follow the procedure below.
Press the side marked " I " of the power
1.
switch, as the power-on position.
The POWER indicator lights up in orange.
● For a couple of seconds after the POWER
indicator lights up, wait to use the control
buttons (on the projector and remote control).
The buttons may not work soon.
Confirm that there is nothing that the lens
2.
door hits while opening.
Then, press the STANDBY/ON button (on
the projector or remote control).
The lens door opens, the projection lamp
lights up, and the POWER indicator begins to
blink green.
When the projector starts completely, the indicator
will turn steady green.
To display the picture, select an input signal according to the section "Selecting an
18).
input signal" (
NOTE
• When the DIRECT POWER ON of the OPTION menu is set to the
TURN ON, and the power was turned off by the power switch last time, turning
the power switch on makes the projection lamp light on without pushing the
STANDBY/ON button (
• Install the projector in the way specified in this manual. Otherwise the
projection lamp may not light.
WARNING
lamp lights, since the projection lamp ray may cause a trouble on your eyes.
►Do not touch around the lamp cover and the exhaust vents during use or just
after use, since it is too hot.
CAUTION
cause an injury.
16
44).
►Never look into the projection lens or mirror while the projection
►Be careful not to pinch your finger with the lens door, as it may
POWER indicator
STANDBY/ON button
LAMP
TEMP
POWER
STANDBY/ON
INPUT
MY SOURCE/
VIDEO
COMPUTER
DOC.CAMERA
ASPECT
AUTO
SEARCH
BLANK
MAGNIFY
FREEZE
VOLUME
ON
OFF
KEYSTONE
MY BUTTON
MUTE
1
2
FOCUS
D-ZOOM
-
+
-
+
POSITION
MENU
ENTER
ESC
RESET
STANDBY/ON button
Power
switch
Advertisement
Table of Contents
