Secure The Drain Hose; Level The Washer; Complete Installation - Whirlpool AUTOMATIC WASHER Use & Care Manual

Laundry tub drain or standpipe drain
Connect the drain hose form to the corrugated drain hose.
A
A. Snap either end of the drain hose form to the drain hose
at the point where the corrugation begins.
B. Bend drain hose over drain hose form and snap into place.
To keep drain water from going back into the washer:
■ Do not straighten the drain hose, and do not force excess drain
hose into standpipe. Hose should be secure, but loose enough
to provide a gap for air.
■ Do not lay excess hose on the bottom of the laundry tub.
Floor drain
You may need additional parts. See Floor drain under "Tools and
Parts."

Secure the Drain Hose

1. Drape the power cord over the washer top.
2. Secure the drain hose to the laundry tub leg or standpipe with
the beaded tie strap provided. (See illustrations A and B.)
A B
If the washer faucets and the drain standpipe are recessed
(see illustration C), put the hooked end of the drain hose in
the standpipe. Tightly wrap the beaded tie strap around the
water inlet hoses and the drain hose.
Do not force excess drain hose into the standpipe.

Level the Washer

Properly leveling your washer avoids excessive noise and vibration.
1. Check the levelness of the washer by placing a level on the
top edge of the washer, first side to side, then front to back.
2. Make sure all four feet are stable and resting on the floor.
3. After the washer is level, use a 17 mm open-end wrench to
4. The washer should not move front to back, side to side,
5. Slide the washer to its final location.
B
6. Confirm the levelness of the washer.
1. Check the electrical requirements. Be sure that you have the
2. Check that all parts are now installed. If there is an extra part,
3. Check that you have all of your tools.
4. Dispose of/recycle all packaging materials.
5. Check that the water faucets are on.
6. Check for leaks around faucets and inlet hoses.
C
7. Plug into a grounded 3 prong outlet.
8. Read "Washer Use."
9. To test and clean your washer, make sure there are no clothes in
If the washer is against a wall, move the washer out slightly
before tipping back. If the washer is not level, first prop the
front with a wood block and adjust the feet as necessary;
then prop the back and adjust feet as necessary. Repeat this
step until washer is level.
Then check that the washer is perfectly level (use a level).
turn the nuts on the feet tightly against the washer cabinet.
IMPORTANT: All four feet must be tightened. If the nuts are
not tight against the washer cabinet, the washer may vibrate.
or diagonally when pushed on its top edges.

Complete Installation

correct electrical supply and the recommended grounding
method. See "Electrical Requirements."
go back through the steps to see what was skipped.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
the washer and add one AFFRESH
Select Power, the Clean Washer cycle and then select START.
This cycle will take approximately 65 minutes to complete. Allow
the washer to complete the entire cycle without interruption.
® tablet to the washer drum.
9