Supermicro Supero 6016T-6F User Manual page 98

S S
UPER ERVER 6016T-6F User's Manual
PCI/PnP Confi guration
Clear NVRAM
This feature clears NVRAM during system boot. The options are No and Yes.
Plug & Play OS
Selecting Yes allows the OS to confi gure Plug & Play devices. (This is not required
for system boot if your system has an OS that supports Plug & Play.) Select No to
allow the AMI BIOS to confi gure all devices in the system.
PCI Latency Timer
This feature sets the latency Timer of each PCI device installed on a PCI bus. Select
64 to set the PCI latency to 64 PCI clock cycles. The options are 32, 64, 96, 128,
160, 192, 224 and 248.
PCI IDE Bus Master
When this feature is enabled, the BIOS uses PCI bus mastering for reading/writing
to IDE drives. The options are Disabled and Enabled.
Slot 1 Option ROM~Slot 7 Option ROM
Select Enabled to enable Slot 1~Slot 6 Option ROMs, which will allow the user
to boot the computer from a PCI device installed on a PCI slot. The options are
Disabled and Enabled.
LAN1 PXE/LAN2 PXE
Select Enabled to enable the onboard LAN1/LAN2 PXE Option ROMs in order
to boot the computer using a network interface. The options are Enabled and
Disabled.

Super IO Device Confi guration
Onboard Floppy Controller
Select Enable to enable the onboard Floppy Controller. The options are Enabled
and Disabled.
Floppy A/Floppy B
This feature allows the user to select the type of fl oppy drive connected to the sys-
tem as specifi ed. The options are Disabled, 360KB 5 1/4", 1.2MB 5 1/4", 720KB 3
1/2", 1.44MB 3 1/2" and 2.88MB 3 1/2". The default setting for Floppy A is 1.44MB
3 1/2", and for Floppy B is Disabled.
7-14