With Both Axles On The Ground; Fuses; Important Safety Notes; Transporting The Vehicle - Mercedes-Benz SLS AMG GT Coupe Operator's Manual

Fuses

244
Switch on the hazard warning lamps
X
( page 98).
Y
Make sure that the SmartKey is in position
X
2 in the ignition and that the engine is
running throughout the towing procedure.
Move the transmission to N with the E-
X
SELECT lever. Check the transmission
position in the instrument cluster.
Towing a vehicle with both axles on
the ground
It is important that you observe the safety
instructions when towing away your vehicle
( page 242).
Y
Switch on the hazard warning lamps
X
( page 98).
Y
i
When towing with the hazard warning
flashers switched on, use the combination
switch as usual to signal in which direction
you are changing. In this case, only the
indicator lamps for the direction of travel
flash. When you reset the combination
switch, the hazard warning flashers start
flashing again.
Insert the SmartKey into the ignition lock
X
( page 119).
Y
Start the engine and leave the SmartKey in
X
the ignition.
Move the transmission to N with the E-
X
SELECT lever.
Check the transmission position in the
X
instrument cluster display (
Leave the engine running throughout the
X
entire towing procedure

Transporting the vehicle

The towing eye can be used to pull the vehicle
onto a trailer or transporter for transporting
purposes.
! You may only secure the vehicle by the
wheels, not by parts of the vehicle such as
axle or steering components. Otherwise,
the vehicle could be damaged.
Start the engine.
X
Make sure that the SmartKey is in position
X
2 in the ignition and that the engine is
running during the entire loading operation.
Move the transmission to N with the E-
X
SELECT lever. Check the transmission
position in the instrument cluster.
As soon as the vehicle has been loaded:
Prevent the vehicle from rolling away by
X
applying the electric parking brake.
Shift the transmission to P with the button
X
in the center console.
Turn the SmartKey to position 0 in the
X
ignition lock and remove the SmartKey
from the ignition lock.
Secure the vehicle.
X
Fuses

Important safety notes

G
If you manipulate or bridge a faulty fuse or if
you replace it with a fuse with a higher
amperage, the electric cables could be
overloaded. This could result in a fire. There
is a risk of an accident and injury.
Always replace faulty fuses with the specified
new fuses having the correct amperage.
page 123).
Y
! Only use fuses that have been approved
for Mercedes-Benz vehicles and which
have the correct fuse rating for the system
concerned. Otherwise, components or
systems could be damaged.
The fuses in your vehicle serve to close down
faulty circuits. If a fuse blows, all the
components on the circuit and their functions
stop operating.
Blown fuses must be replaced with fuses of
the same rating, which you can recognize by
WARNING