Mercedes-Benz SLS AMG GT Coupe Operator's Manual page 215

Select key position 2 with the Start/Stop
X
button ( page 119).
Y
Press the programing button of the door or
X
gate drive (see the door or gate drive
operating instructions, e.g. under
"Programing additional remote controls").
i
Usually, you now have 30 seconds to
initiate the next step.
Press previously programed button ;, =
X
or ? of the integrated garage door opener
until the door closes.
The rolling code synchronization is then
complete.
Notes on programing the remote control
Canadian radio frequency laws require a
"break" (or interruption) of the transmission
signals after broadcasting for a few seconds.
Therefore, these signals may not last long
enough for the integrated garage door
opener. The signal is not recognized during
programing. Comparable with Canadian law,
some U.S. garage door openers also feature
a "break".
Proceed as follows:
if you live in Canada
R
if you have difficulties programing the
R
garage door opener (regardless of where
you live) when using the programing steps
Press and hold one of buttons ; to ? on
X
the integrated garage door opener.
After a short time, indicator lamp : lights
up yellow.
Release the button.
X
Indicator lamp : flashes yellow.
Press button B of garage door remote
X
control A for two seconds, then release it
for two seconds.
Press button B again for two seconds.
X
Repeat this sequence on button B of
X
remote control A until indicator lamp :
lights up green.
If indicator lamp : turns red, repeat the
process.
Continue with the other programing steps
X
(see above).
Problems when programing
If you are experiencing problems programing
the integrated garage door opener on the
rear-view mirror, take note of the following
instructions:
Check the transmitter frequency of garage
R
door drive remote control A. This can
usually be found on the back of the remote
control.
The integrated garage door opener is
compatible with devices that have units
which operate in the frequency range of
280 to 433 MHz .
Replace the batteries in garage door
R
remote control A. This increases the
likelihood that garage door remote control
A will transmit a strong and precise signal
to the integrated garage door opener in the
rear-view mirror.
When programing, hold remote control A
R
at varying distances and angles from the
button that you are programing. Try various
angles at a distance between 2and
12 inches (5to 30 cm) or at the same angle
but at varying distances.
If another remote control for the same
R
garage door drive is available, repeat the
same programing steps with this remote
control. Before performing these steps,
make sure that new batteries have been
installed in garage door drive remote
control A.
Note that some remote controls only
R
transmit for a limited amount of time (the
indicator lamp on the remote control goes
Features
213
Z