▶
Remote Access Configuration
▶
Remote Access
The settng enables/dsables the remote access functon. When set to [En-
abled], users may configure the following settings for remote access type and
parameters.
▶
Serial Port Number, base Address, IRQ, Serial Port Mode
Use these settings to configure ports for remote access.
▶
Flow Control
Flow control s the process of managng the rate of data transmsson between
two nodes. It's the process of adjusting the flow of data from one device to an-
other to ensure that the recevng devce can handle all of the ncomng data.
Ths s partcularly mportant where the sendng devce s capable of sendng
data much faster than the recevng devce can receve t.
▶
Redirection After bIOS POST
Ths settng determnes whether or not to keep termnals?console redrecton
runnng after the BIOS POST has booted.
▶
Terminal Type
To operate the system's console redrecton, you need a termnal supportng
ANSI termnal protocol and a RS-232 null modem cable connected between
the host system and terminal(s). This setting specifies the type of terminal
devce for console redrecton.
▶
VT-UTF8 Combo Key Support
Ths settng enables/dsables the VT-UTF8 combnaton key support for ANSI/
VT100 termnals.
▶
Sredir Memory Display Delay
Use ths settng to set the delay n seconds to dsplay memory nformaton.
MS-9297
MS-9297
4-17