Super Io Configuration - MSI MS-9297 User Manual

▍ ▍
BIOS Setup BIOS Setup
▶
Primary/Secondary/Fourth IDE Master/Slave
[Type]
[LBA/Large Mode]
[Block(Mult-Sector
Transfer)]
[PIO Mode]
[DMA Mode]
[S.M.A.R.T.]
[32 Bt Data Transfer]
▶

Super IO Configuration

▶
Serial Port 1 Address, Serial Port 2 Address
Select an address and a correspondng nterrupt for the seral port 1/2.
4-8
Press PgUp/<+> or PgDn/<-> to select [Manual], [None] or [Auto] type.
Note that the specifications of your drive must match with the drive
table. The hard dsk wll not work properly f you enter mproper nfor-
maton for ths category. If your hard dsk drve type s not matched or
listed, you can use [Manual] to define your own drive type manually.
Enablng LBA causes Logcal Block Addressng to be used n place of
Cylnders, Heads and Sectors
Any selecton except Dsabled determnes the number of sectors trans-
ferred per block
Indcates the type of PIO (Programmed Input/Output)
Indcates the type of Ultra DMA
Ths allows you to actvate the S.M.A.R.T. (Self-Montorng Analyss &
Reportng Technology) capablty for the hard dsks. S.M.A.R.T s a utl-
ty that montors your dsk status to predct hard dsk falure. Ths gves
you an opportunty to move data from a hard dsk that s gong to fal to
a safe place before the hard disk becomes offline.
Enables 32-bt communcaton between CPU and IDE controller