Port LEDs
The following table describes the RJ-45 and combo SFP+ port LED designations. Each
RJ-45 port has two LEDs. Each SFP+ port has its own indication LEDs.
Table 1. Port LEDs
LED
Link/Speed/ACT LED mode for
copper ports 1 to 12
Link/ACT LED for SFP+ ports
11 and 12
System LEDs
The following table describes the system LED designations.
Table 2. System LEDs
LED
Power
Fan
Device Hardware Interfaces
The following sections describe the hardware interfaces on the device.
XS712T Smart Switch
Designation
•
Off. No link established.
•
Solid green (left side). A valid 10-Gbps link is established.
•
Blinking green (left side). The port is transmitting or receiving
packets at 10 Gbps.
•
Solid yellow (right side) . A valid 100/1000-Mbps link is established.
•
Blinking yellow (right side). The port is transmitting or receiving
packets at 100/1000 Mbps.
•
Off . No SFP+ module link is established.
•
Solid green (left side) . A valid 10-Gbps link is established.
•
Blinking green (left side). The port is transmitting or receiving
packets at 10 Gbps.
•
Solid yellow (right side) . A valid 1000-Mbps link is established on
the port.
•
Blinking yellow (right side) . The port is transmitting or receiving
packets at 1000 Mbps.
Designation
•
Solid green . The device is powered on; runtime code is operating.
•
Solid yellow . The device is booting up.
•
Off . Power is not supplied to the device.
•
Solid yellow . The fan has experienced a failure.
•
Off . The fan is operating normally.
11