Table of Contents
Advertisement
N300 Wireless Router Model JWNR2000Tv3
Note:
If you change the LAN IP address of the router while connected
through the browser, you will be disconnected. You must open a new
connection to the new IP address and log in again.
To change the LAN settings:
1.
Select Advanced > Setup > LAN Setup to display the following screen:
2.
Enter the settings that you want to customize.
These settings are described in the following section,
3.
Click Apply to save your changes.
LAN Setup Screen Settings
You can configure the following LAN settings:
•
LAN TCP/IP Setup:
•
IP Address. The LAN IP address of the router.
•
IP Subnet Mask. The LAN subnet mask of the router. Combined with the IP address,
the IP subnet mask allows a device to know which other addresses are local to it, and
which must be reached through a gateway or router.
•
RIP Direction. Router Information Protocol (RIP) allows a router to exchange routing
information with other routers. This setting controls how the router sends and receives
RIP packets. Both is the default setting. With the Both or Out Only setting, the router
broadcasts its routing table periodically. With the Both or In Only setting, the router
incorporates the RIP information that it receives.
•
RIP Version. This setting controls the format and the broadcasting method of the RIP
packets that the router sends. It recognizes both formats when receiving. By default,
the RIP function is disabled.
LAN Setup Screen
Settings.
41
Advertisement
Table of Contents
