Default Configuration Settings
You can use the reset button located on the front of your device to reset all settings to their factory
defaults. This is called a hard reset.
•
To perform a hard reset, push and hold the reset button for approximately 5 seconds (until the
TEST LED blinks rapidly). Your device will return to the factory configuration settings shown
in
Table A-1
below.
•
Pressing the reset button for a shorter period of time will simply cause your device to reboot.
Table A-1. Access Point Default Configuration Settings
Feature
AP Login
User Login URL
User Name (case sensitive)
Login Password (case sensitive)
Access Point Name
Ethernet Connection
Ethernet MAC Address
Port Speed
Local Network (LAN)
Lan IP
Subnet Mask
DHCP Client
Default Configuration and Technical
Description
192.168.0.227
admin
password
NETGEARxxxxxx where xxxxxx are the last six digits of
the WG602v4 MAC address
See bottom label.
10/100
192.168.0.227
255.255.255.0
Enabled
v1.0, June 2007
Appendix A
Specifications
A-1