NETGEAR WG602v4 Reference Manual page 27

Netgear 54 mbps wireless access point
Hide thumbs Also See for WG602v4:
Table of Contents

Advertisement

Country/Region. Identifies the region where the WG602v4 can be used. It may not be
legal to operate the access point in a country/region other than the country/region for your
area. If your country or region is not listed, please check with your local government
agency or check our website for more information on which channels to use.
Note: You must set the Regulatory Domain. It may not be legal to operate the
Channel/Frequency. Identifies which operating frequency will be used. It should not be
necessary to change the wireless channel unless you notice interference problems or if you
are setting up the WG602v4 near another access point. The available wireless channels are
between 1 and 11 in the US and Canada, and between 1 and 13 for Europe and Australia.
If using multiple access points, it is better if adjacent access points use different
channels to reduce interference. The recommended channel spacing between adjacent
access points is 5 channels (for example, use channels 1 and 6, or 6 and 11).
In "Infrastructure" mode, wireless stations normally scan all channels, looking for an
access point. If more than one access point can be used, the one with the strongest
signal is used. This only occurs when the various access points are using the same
SSID Mode. The default is g and b. You can change the mode to g or b only.
Data Rate. Shows the available transmit data rate of the wireless network. The possible
data rates supported are: 1 Mbps, 2 Mbps, 5.5 Mbps, 6 Mbps, 9 Mbps, 11 Mbps, 12 Mbps,
24 Mbps, 36 Mbps, 48 Mbps, 54 Mbps, and Best.The default is Best.
3. Click Apply to save any changes.
Now that you have finished the setup steps, you are ready to deploy the WG602v4 in your
network. If needed, you can now reconfigure the PC you used in step 1 back to its original TCP/IP
settings.
Tip: Before mounting the WG602v4 in a high location, first set up and test the WG602v4
to verify wireless network connectivity.
Installation and Configuration
NETGEAR 54 Mbps Wireless Access Point WG602v4 Reference Manual
wireless access point in a region other than one of those identified in this
field.
v1.0, June 2007
2-7

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents