NETGEAR WG602v4 Reference Manual page 26

NETGEAR 54 Mbps Wireless Access Point WG602v4 Reference Manual
• IP Subnet Mask: 255.255.255.0
• Gateway: 0.0.0.0
If your network has a requirement to use a different IP addressing scheme, you can make those
changes on this screen.
6. Click Apply to save any changes.
.
Note: If you change the default subnet of the LAN IP address, you will be disconnected from the
Wireless AP user interface. To reconnect, reconfigure your computer with a static IP
address within the new LAN IP subnet.
To configure your basic wireless settings:
1. From under the Setup menu, select Wireless Settings. The Wireless Settings screen will
display.
Figure 2-5
2. Enter or modify the wireless settings appropriate to your network:
• Wireless Network Name (SSID). The SSID is the wireless network name. Enter a value
of up to 32 alphanumeric characters; the characters are case sensitive. In a setting where
more than one wireless network is present, using a different wireless network name allows
your to separate the traffic. Any device you want to participate in a particular wireless
network needs to use the SSID. The default SSID is: NETGEAR.
• SSID Broadcast. If SSID Broadcast is disabled, only devices that have the correct SSID
can connect. The default is Enable.
2-6
v1.0, June 2007
Installation and Configuration