Component Function And Identification - Graco ULTRA R MAX 695 309067 Instructions-Parts List Manual

Component Function and Identification

S
K
J
232665, 232918, 232916, 232919 and 232914
Fig. 1
A Motor (Under shield shown)
B Pressure Adjusting Knob
C ON/OFF Switch
D Drive Assembly
E Fluid Filter
F Fluid Outlet
G Pail Hanger
H Displacement Pump
J 50 ft (15 m) Main Hose
K RAC 5 Tip Guard
L Contractor Gun
M RAC 5 Switch Tip
N 3 ft (0.9 m) Hose
P Pressure Drain Valve
R Pressure Control
S Spray Gun Safety Latch
B
R
E
F
G
M
H
L
N
DC motor, permanent magnet, totally enclosed, fan cooled
Controls fluid outlet pressure
Power switch that controls VAC main power to sprayer
Transfers power from DC motor to the displacement pump
Filter of fluid between source and spray gun
Main hose to spray gun is connected here
Container for fluid to be sprayed may be hung here
Transfers fluid to be sprayed from source through spray gun
1/4 in. ID, grounded, nylon hose with spring guards on both ends
Reverse-A-Clean (RAC) tip guard reduces the risk of fluid injection injury
High pressure spray gun with gun safety latch
RAC switch tip uses high pressure fluid to remove clogs from spray tip
without removing tip from spray gun
3/16 in. ID, grounded, nylon hose used between 50 ft hose and spray gun
to allow more flexibility when spraying
Relieves fluid outlet pressure when open; diverts fluid to drain line
Controls motor speed to maintain fluid outlet pressure at displacement
pump outlet. Works with pressure adjusting knob.
Inhibits accidental triggering of spray gun
A
D
R
P
C
9661A