Sky Command Ii (K-Type Only) - Kenwood TS-480HX Instruction Manual

14 CONNECTING PERIPHERAL EQUIPMENT

SKY COMMAND II (K-TYPE ONLY)

■ TM-D700A
In order to connect the TS-480 transceiver to the
TM-D700A transceiver, you need to prepare
3 cables by yourself. For the connection between
the COM connectors on the 2 transceivers, you
may use a commercially available RS-232C cross-
wired cable.
Note:
◆ Switch OFF both the TM-D700 and TS-480 transceiver before
making the connection.
◆
The TM-D700A transceiver automatically transmits its call sign
in Morse code at regular intervals because of legal
requirements; therefore, transmit sidetone must be output
from the TS-480 transceiver.
◆
When the TM-D700A transceiver is too close to the TS-480
transceiver, unwanted feedback may cause malfunction.
◆ Do not share a regulated power supply between the
TM-D700A transceiver and the TS-480 transceiver. Unwanted
feedback may cause malfunction.
80
TM-D700A
transceiver
COM
connector
3.5 mm (1/8 ")
speaker jack
UP
8 V DC
GND
STBY (MIC)
GND (MIC)
MIC
RJ-45
NC
MIC jack
DWN
TS-480
transceiver
COM
connector
UP
8 V DC
GND
STBY (MIC)
GND (MIC)
RJ-45
MIC
NC MIC jack
DWN
3.5 mm (1/8 ")
speaker jack