A Utomatic R Epeater O Ffset (K Type Only ) - Kenwood TH-255A Instruction Manual

A r
utoMAtic
This function automatically selects an offset direction, according to
the frequency on the 2 m band. The transceiver is programmed for
offset directions as shown below. To obtain an up-to-date band plan
for repeater offset direction, contact your national Amateur Radio
association.
1 Enter Menu mode and access Menu No. 25 (ARO).
2 Press [MENU], then rotate the Selector (or press [UP]/ [DOWN])
to select "ON".
3 Press [MENU] to store the setting.
• You will be transmitting on an offset frequency value
determined from your offset setting value {page 20} and an
offset direction depending on your selected frequency. Refer
to the settings below for offset directions:
4 Press any key other than [MON], [UP]/ [DOWN] or [ ] to exit
Menu mode.
Under 45.00 MHz: No offset (Simplex operation)
45.00 ~ 45.499 MHz: Minus (–) offset
45.500 ~ 45.999 MHz: No offset (Simplex operation)
46.000 ~ 46.399 MHz: Plus (+) offset
46.400 ~ 46.599 MHz: No offset (Simplex operation)
46.600 ~ 46.999 MHz: Minus (–) offset
47.000 ~ 47.399 MHz: Plus (+) offset
47.400 ~ 47.599 MHz: No offset (Simplex operation)
47.600 ~ 47.999 MHz: Minus (–) offset
48.000 MHz and higher: No offset (Simplex operation)
o
epeAter FFSet
(k )
type only
23