Dx Packetcluster Tune; Crossband Repeater - Kenwood TS-480HX Instruction Manual

Hf/ 50 mhz all mode transceiver
Hide thumbs Also See for TS-480HX:
Table of Contents

Advertisement

DX PACKETCLUSTER TUNE

If you have a TM-D700 transceiver, you can connect the TM-D700 to the TS-480 transceiver to use the DX
PacketCluster Tune function. Connect the 2 transceivers with a cross-wired RS-232C cable as shown below.
Configure the TM-D700 transceiver to the DX PacketCluster node frequency.
Cross-wired cable
1 Press [MENU/ F.LOCK] and turn the MULTI control to select Menu No. 56 on the TS-480 transceiver.
2 Press [ ]/ [ ] to select the same communication baud rate configured on the TM-D700 transceiver.
3 Tune to the DX PacketCluster node frequency on the TM-D700 transceiver.
4 Press [F] (1 s), [TNC] on the TM-D700 transceiver.
"TNC APRS" appears on the TM-D700 transceiver.
5 Press [F] (1 s), [DX] on the TM-D700 transceiver.
6 Select a desired DX station data with [c c c c c ]/ [d d d d d ] on the TM-D700 transceiver.
7 Press [MHz] on the TM-D700 transceiver to transfer the frequency data to the TS-480 transceiver.
If the transferred frequency data is available on the TS-480 transceiver, the frequency data will be
overwritten to the current operating frequency. Otherwise, the operating frequency of the TS-480
transceiver remains unchanged.
For more detailed operation on the DX PacketCluster operation of the TM-D700 transceiver, refer to page 6 of the
TM-D700 instruction manual (Specialized Communications).
The firmware of the TM-D700 transceiver must be version G2.0 or later to use the DX PacketCluster Tune function.
Note:

CROSSBAND REPEATER

If you have a TM-D700 transceiver, you can connect the TM-D700 transceiver to the TS-480 transceiver to use
the Crossband repeater function. Connect the 2 transceivers with a mini DIN cable (6-pin) as shown below.
To DATA connector
After connecting the 2 transceivers with the cable, access Menu No. 57 (DTS polarity) on the TS-480 transceiver
and select "on". You will further need to adjust the audio input/ output level of the TS-480 transceiver using Menu
Nos. 46 and 47.
e
TS-480 transceiver
TS-480 transceiver
TS-480
t
y
ANI
ANG
DTS
r
NC
ANO
q
w
SQC
Mini DIN
Mini DIN
6-pin male
6-pin male
14 CONNECTING PERIPHERAL EQUIPMENT
TM-D700 transceiver
CO M
DA TA
GP S
PA NE L
MIC
RE SE T
TM-D700 transceiver
CO M
DA TA
GP S
PA NE L
MIC
RE SE T
To DATA connector
TM-D700
q
q
PKD
w
w
DE
e
e
PKS
r
r
PR9
t
t
PR1
y
y
SQC
Mini DIN
6-pin male
79

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ts-480sat

Table of Contents