Software; Figure 2-13 Removing A Memory Card; Figure 2-14 Memory Card Removed - Hitachi GR2000-B Series Quick Start Manual

Hitachi Gigabit Router GR2000-B Series Quick Start Guide
2. Push the lever toward the direction indicated by the arrow as shown in Figure
2-13 below.
Lever
Memory Card

Figure 2-13 Removing a Memory Card

3. Pull out the memory card as shown in Figure 2-14 below.
Mem ory Card

Figure 2-14 Memory Card Removed.

Caution:
!
2.8

Software

Software is preinstalled on the memory card when the GR2000-B is shipped. Refer to
the GR2000 Applications Guide for procedures for re-installing software onto a
memory card.
2-10
While the access indicator (ACCESS) for a memory card is lit, the memory
card is being accessed. DO NOT pull out a memory card or turn off the
power switch while the memory card is being accessed. If so, you could
permanently damage the memory card.
Some commands require a long time to finish accessing a memory card
when they are executed. Make sure that the access to a memory card is
finished before pulling it out or turning off the power switch.
GR2K-GA-0008
Rev. 1.00