Table of Contents
Advertisement
Installing the processor with heat sink and fan
Ê
Remove the heat sink including the fan fixed upon it.
Ê
Pull the lever in the direction of the arrow (1) and lift it as far as it will go (2).
Ê
Remove the old processor from the socket (3).
Ê
Insert the new processor in the socket so that the angled corner of the processor matches the
coding on the socket (A) with regard to the position (4).
Push the lever back down until it clicks into place (5).
Mounting heat sink
If you are installing the heat sink you must ensure a good heat contact between heat sink and the
processor´s surface. It is essential to use heat conducting material between the processor and the
heat sink.
If you remove the heat sink, you must clean it (e.g. with benzine) and apply new heat conducting
paste before you remount it.
Please note that, depending on the heat sink used, different heat sink mounts are required on the
mainboard.
Since a counter-plate is mounted on the underside of the mainboard for reinforcement, no
i
heat sinks of the type "Intel Boxed" may be used. Otherwise the retaining clips of the heat
sink will be damaged.
Only use the supplied heat sink and the supplied retaining springs.
A26361-D1501-Z120-2-7419
2
2
3
3
1
1
Add-on modules
4
4
5
5
A
A
English - 19
Advertisement
Table of Contents
