Maintenance And Troubleshooting - NordicTrack NTEX03912.1 User Manual

MAINTENANCE AND TROUBLESHOOTING

Inspect and tighten all parts of the exercise bike regu-
larly. Replace any worn parts immediately.
To clean the exercise bike, use a damp cloth and a
small amount of mild soap. IMPORTANT: To avoid
damage to the console, keep liquids away from
the console and keep the console out of direct
sunlight.
CONSOLE TROUBLESHOOTING
If lines appear in the console display, see step 4 on
page 24 and adjust the contrast level of the display.
If the handgrip heart rate monitor does not function
properly, see step 5 on page 19.
If a replacement power adapter is needed, call the
telephone number on the cover of this manual.
IMPORTANT: To avoid damaging the console, use
only a manufacturer-supplied regulated power
adapter.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted.
To adjust the reed switch, first unplug the power
adapter. Using a flat screwdriver, release the tabs on
the Shield Cover (5) and pull the Shield Cover upward.
Locate the Reed Switch (46). Turn the Pulley (58) until
a Magnet (29) is aligned with the Reed Switch. Next,
loosen, but do not remove, the indicated M4 x 13mm
Flange Screw (70). Slide the Reed Switch slightly
closer to or away from the Magnet, and then retighten
the Screw. Plug in the power adapter and turn the
Pulley for a moment.
Repeat these actions until the console displays correct
feedback. When the reed switch is correctly adjusted,
reattach the shield cover.
26
70
29
46
5
58