Introduction To Web-Based Switch Configuration; Introduction; Logging On To The Web Manager - D-Link DES-3010F Manual

DES-3010F/DES-3010FL/DES-3010G/DES-3018/DES-3026 Fast Ethernet Switch Manual
Introduction to Web-based Switch
Configuration

Introduction

Logging on to the Web Manager

Web-Based User Interface
Basic Setup
Reboot
Basic Switch Setup
Network Management
Switch Utilities
Network Monitoring
IGMP Snooping Status
Introduction
All software functions of the DES-3018 switch can be managed, configured and monitored via the embedded web-based
(HTML) interface. The Switch can be managed from remote stations anywhere on the network through a standard browser
such as Netscape Navigator/Communicator, Mozilla or Microsoft Internet Explorer. The browser acts as a universal access
tool and can communicate directly with the Switch using the HTTP protocol.
The Web-based management module and the Console program (and Telnet) are different ways to access the same internal
switching software and configure it. Thus, all settings encountered in web-based management are the same as those found
in the console program.
Logging on to the Web Manager
To begin managing your Switch, simply run the browser you have installed on your computer and point it to the IP address
you have defined for the device. The URL in the address bar should read something like: http://123.123.123.123, where the
numbers 123 represent the IP address of the Switch.
In the page that opens, click on the Login button:
This opens the management module's user authentication window, as seen below.
NOTE: The Factory default IP address for the Switch is 10.90.90.90.
Figure 5- 1. Login Button
Section 5
23