Connecting The Switch; Switch To End Node - D-Link DES-3010F Manual
Managed 8/16/24-port 10/100mbps fast ethernet switch with optional slots
Hide thumbs
Also See for DES-3010F:
- Command line interface manual (231 pages) ,
- User manual (225 pages) ,
- Manual (186 pages)
Table of Contents
Advertisement
DES-3010F/DES-3010FL/DES-3010G/DES-3018/DES-3026 Fast Ethernet Switch Manual
Connecting the Switch
Switch To End Node
Switch to Hub or Switch
Connecting To Network Backbone or Server
Switch to End Node
End nodes include PCs outfitted with a 10, 100 or 1000 Mbps RJ 45 Ethernet Network Interface Card (NIC) and most
routers.
An end node can be connected to the Switch via a twisted-pair UTP/STP cable. The end node should be connected to any
of the 10/100BASE-T ports of the Switch.
The Link/Act LEDs for each UTP port will light green or amber when the link is valid. A blinking LED indicates packet
activity on that port.
NOTE: All high-performance N-Way Ethernet ports can support both MDI-
II and MDI-X connections.
Figure 3- 1. Switch connected to an end node
Section 3
12
Advertisement
Table of Contents
