Install Outdoor Unit - Sanyo SAP-K18AM Instruction Manual

10. INSTALL OUTDOOR UNIT

10.1 Wiring Instructions for the
Outdoor Unit
Regulations on wire size differ from locality.
For field wiring requirements, please refer to
your local electrical codes. Make sure that
the installation fully complies with all local
and national regulations.
1. Disassemble the handle on the outdoor
unit right side plate. (Screw x 1pc)
2. Take off wire clamp, connect and fix
power connect cord to terminal of line
bank. Connect the inter-unit wiring and
power line according to the drawing on
the handle.
3. Fix the power connection cable with wire
clamp. (Fig. 24 / 25)
NOTE
Use the wire clamp to fix the
signal control wire, then
connect to the corresponding
connector.
4. Be sure to size each wire allowing approx.
10 cm longer than the required length for
wiring, Store excess wiring inside the
cabinet.
5. When connections are completed, check
that all connections are correct as shown
in the wiring system diagram on the
handle.
6. Be sure to ground the unit according to
your local codes.
7. Install back the handle. (Screw x 1pc)
Installation Service
Handle
Handle
(Cooling Only Model )
3
Blue
Yellow-green
Black
Brown
Wire clamp
1.
2.
Fig. 24
(Heat Pump Model )
3 4
5
Blue
Black Brown Violet Orange
Wire clamp
Fig. 25
28