Table of Contents
Advertisement
CONNECTION WITH OTHER EQUIPMENT
About the jacks and connections of rear panel
1.Refer to the operation manual of your electronic equipment for additional information on connections.
2.If your device has only one audio output (mono sound), please connect it to the left channel jack (L/MONO).
3.Audio and video signal from the same source should be connected to the same group of terminals. Do not mix
them.
4.Terminals Y/VIDEO,P
STB, DVD, PDVD, etc. Y/VIDEO input terminal can also be used as the standard video terminal.
When you use Y/VIDEO, P
the remote control unit to show the characters COMPONENT and AV1 or AV2 on the top right corner of the
screen, which indicates that you are using component terminals to receive signals. However, when you use
Y/VIDEO terminal instead of Y/VIDEO, P
or AV2 will appear on the top right corner of the screen.
The HDMI INPUT interface on INPUT1 can be used to connect your external devices equipped with an HDMI
output. When the HDMI INPUT interface on INPUT1 is connected, press the RECALL button on the remote
control unit to show the characters HDMI or DVI and AV1 on the top right corner of the screen, which
indicates that you are viewing the program through the HDMI INPUT interface on INPUT1.
Note: 1. When the HDMI INPUT interface on INPUT1 is used, please do not connect terminals (Y/VIDEO
P
/C
P
/C
B
B
R
R
2. The C43-FL9000 model does not have HDMI INPUT interface.
5.If your device has s-video signal output, please use s-video signal instead of the standard video signal.
If there are signals input from the same group of S-VIDEO and VIDEO terminals, the TV will receive signal
from S-VIDEO and the characters S and AV3 or AV4 will appear on the top right corner of the screen by
pressing the RECALL button, which indicates that you are using S-VIDEO terminal to receive signals.
6. VIDEO MONITOR OUT terminal outputs video signal receiving from RF, S-VIDEO or VIDEO terminal to
external equipment. When receiving component signals (Y P
there is no output from VIDEO MONITOR OUT terminal.
7. S-VIDEO MONITOR OUT terminal outputs S-VIDEO signal receiving from S-VIDEIO inputs to external
equipment. When receiving signals from RF, VIDEO, Y, P
there is no output from S-VIDEO MONITOR OUT terminal.
8. FIXED/VARIABLE AUDIO MONITOR OUT terminals provide fixed or variable audio level output to
external stereo system.
9.TV AS CENTER input jacks
These jacks are for stereo amplifiers with center signal output capability. This feature allows the TV speakers to
be used as a center speaker.
/C
,P
/C
in INPUT1 and INPUT2 are used to connect component outputs of HDTV
B
B
R
R
/C
, P
/C
terminals to connect component signals, press the RECALL button on
B
B
R
R
/C
, P
B
B
) on INPUT1.
/C
terminals to receive video signal, only the character AV1
R
R
/C
P
/C
B
B
R
R
/C
, P
/C
terminals or HDMI INPUT interface,
B
B
R
R
52
) or HDMI INPUT interface signal,
Advertisement
Table of Contents
