Table of Contents
Advertisement
ON-SCREEN DISPLAY MENU SETUP MENU
10
If the picture is noisy due to weak RF signals from
some channels, you can reduce noise by using TV NR
function.
Press the
cursor buttons to select the TV NR option
and then press the
and High to turn off noise reduction function, activate low
noise reduction and high noise reduction respectively.
Different channels can be set independently.
Note: This option is valid only for RF signal from
antenna.
11
All Program in Tuning menu can automatically
search all available frequencies and store all stations
available to the program numbers starting from the current
program No.
Press the
cursor buttons to select the Program
Number option on the menu, press the
buttons or number buttons to select program No.
Press the
cursor buttons to select the All Program
option as shown on the right. Then press the ENTER
button to begin the auto tune procedure. The word
Searching will appear at the bottom of the menu, and the
TV will search for all frequencies and store all tuned
frequencies to the program numbers starting from the
Program Number selected.
In the process of searching, press the ENTER button to quit.
After complete the searching, the TV will quit the menu automatically.
AV PRESETTING
Press the TV/VIDEO button to switch the picture to the
AV mode.
Enter the Preset menu to display the menu as shown on the
right. Press the
Mode option and the
TV/VIDEO button to select AV1, AV2, AV3, AV4 or
AV5.
Press the
cursor buttons to select the Color System
option, then press
PAL, SECAM, NTSC4.43 or NTSC3.58.
If the picture in AV mode is abnormal resulted from
incorrect color system, you can use the Color System
option to select the correct system.
When receiving component signal (Y, P
terminal, though the Color System option can be set, it has no effect on the picture. This is normal. (The
C43-FL9000 model does not have HDMI INPUT interface.)
cursor buttons to select Off, Low
cursor buttons to select the AV
cursor buttons or the
cursor buttons to select Auto,
/C
, P
B
B
R
cursor
/C
) from INPUT1 (or HDMI INPUT interface) or INPUT2
R
26
Advertisement
Table of Contents
